Updated Penetrations

The cables I have are just placeholders here.  Please identify which cables you need for you hardware setup and fill in the

cable type with diameter and length required.

My best information right now is:

West Penetration (66 ft to magnet rack): All connections running to the magnet rack (plus thermocouple lines)

East Penetration (22 ft out of penetration, 47 feet to cryoplatform): Only NMR possible microwave-water

Front Penetration (55 ft to cryoplatform) : All other cabling

West Penetration

--------------------------------

(Cryo)

Vapor return for QT transferline (0.5 inch SS/copper line with 0.5-1 inch foam)

QT transferline for LHe magnet filling (see QT step)    

Main Flow (10 inch SS)

Separator Flow (25 mm flex hose with 1-2 inch foam)

LN2 fill (copper tubing with 5-6 inch foam)

He gas (1/8 hose HDPE for gas lines for backfilling fridge)

(Electrical)

Magnet power (two 14 mm cables) (66 ft from magnet to magnet power-supply on cryo-platform)

Internal magnet sensors

External magnet sensors TC lines (sixteen 1 mm cables) (highly length sensitive)

LHe level probe (one 7 mm cable)

LN2 level probe (one 7 mm cable)

Shim power (two 7 mm cable)

Top ceiling Penetration

-------------------------------

Magnet boil off exhaust (25 mm flex hose with 0.5-1 inch foam) back to QT T-ed outside of cave to Quench relief outside of Hall

LN2 port exhaust (25 mm flex hose with 0.5-1 inch foam) should have a fan pulling vapor

East Penetration (less than 47ft from target to cryo-platform)

--------------------------------

NMR lines <30 mm dim collection of multiple coax (highly length sensitive)

EIP cable 4 mm gore cable

Top Front-East Opening (shortest length is about 55ft from target to cryo-platform)

--------------------------------

(Other)

Water lines for Microwave (two 3/8" SS tubing)

Pneumatic air lines (two 3/8" SS tubing)

(Cryo)

Manometer (25 mm flex hose with 1-2 inch foam)

(Electrical)

Annealing cables (one 7 mm cable)

Insert sensors (one 7 mm cable)

Fridge sensors (one 7 mm cable)

2 pressure sensors cabling (two 7 mm cable)

Microwave HV cables to PS (one 20 mm cable) needs line conditioner

Microwave stepper controls (three 4 mm cable)

Actuator controls (two 7 mm cable)

All instrumentation for vacuum turbo will run along this path as well but not through penetration

Bottom Front-East Opening (To Vacuum setup)

--------------------------------

pfeiffer pressure sensor

turbo pump (KF-25 flex)

backing pump (no penetration)

turbo controller (no penetration)

Connect from Outside of Cave to Cryoplatform

--------------------------------

HFM-305 flow meter

HFC-303 flow controller

THCD-400 4-channel readout controller

PS AF-100-AM interconnecting cable (100 ft long)

--------------------------------